Complete Hydraulic Drive unit assembly for Over/Under Conveyor consisting of:
Hydraulic Motor (#1MOTOR-HY835)
Motor to gearbox adapter (#1HYDRA-PR500)
Gearbox (#1GEABX500)
Sprocket (#1SPROCC500)
...
2" OD x 19-3/4" long (including bushings) Stainless Steel Roller used on the short side of the "Y" section. This roller comes with roller bushings for 3/4" axles. The first style of Y-section rollers ...
Demand ramp arm for Over/Under Conveyor Style #5. This part number reflects the complete arm assembly with brass bushings pressed into it. Replaces #269.
Used on:
Over/Under Conveyor Style #5
Stainless Steel Acme Threaded Rod used to adjust tension on the Over/Under Conveyor from Style #2 (June 1986) to Current style #5.
Used on:
Over/Under Conveyor from Style #2 (June 1986) to Current s...
Spring retainer plate assembly that is attached to the push bar for the idler sprocket on Over/Under Conveyor.
Used on:
Over/Under Conveyor from Style #2 (June 1986) to Current style #5.
Carriage assembly located in the Entrance Section of the Over/Under Conveyor. Supports the Right Hand side of the 2" stainless steel axle of the idler sprocket Assembly. This carriage allows the idler...
Carriage assembly located in the Entrance Section of the Over/Under Conveyor. Supports the Left Hand side of the 2" stainless steel axle of the Idler sprocket Assembly. This carriage allows the Idler...
Steel Dollie complete assembly. Comes complete with rollers, hardware and triangle plates.
Used on:
Over/Under conveyors from June 1986 to Present. Style #2 through #6.
Conveyor On Demand Trap Door assembly. For Over/Under Conveyors sold after March 1995 #101788 (redesigned style) or #100880 can be used.
Used on:
Entrance section for Over/Under Conveyors Style #2...
Conveyor carriage assembly designed to float while pushing idler sprocket in Entrance of Over/Under Conveyor. This carriage accepts pusher rod that extends between carriage and tension spring retainer...
Conveyor spring retainer assembly that bolts onto the frame of the conveyor which accepts dual chain tension springs (1SPRNG042).
Used on:
Entrance section for Over/Under Conveyors Style #2 through...
Steel/Cadmium plated clutch plate assembly used with clutch hubs on Wrap Arounds. This plate uses a taper-lock bushing to secure itself to the Wrap Shaft and support the clutch hub. Used for both 8" ...
Conveyor demand ramp arm comes with the hub pre-welded for Conveyor Style #5 (After July 1988), and does not come pre-welded for Conveyor Styles #1 - #4 (Before July 1988). Specify which style Conveyo...
Print Page